Article & News

The moment someone mentions “junction box,” most folks either shrug or frown. And I get it—it sounds like something only electricians care about. An electrical

You’ve seen them everywhere—protecting electronics, sitting under control panels, or housing power supplies. But what really goes into making a sheet metal enclosure? A sheet

It usually starts with a quick request from a client—“Can you make it in polycarbonate?” Sounds simple. But what they’re really asking is: Can it

It usually starts in the middle of a project, not at the beginning. The enclosure design is almost done. The PCB layout is locked. The

Sometimes a project seems straightforward—until someone brings up protection ratings. You’re deep in CAD files, choosing materials, finalizing shapes… and then the client asks, “Can

There’s a moment that comes up again and again in my daily work. A product is almost ready. The PCB is tested. The software runs

A message came through from a client working on an outdoor EV charger. It was just one sentence: “Can I leave this control box in

Choosing between NEMA 4 and IP65 doesn’t always start with a technical discussion. Sometimes it begins with a quiet message from a client. One line.

Some topics come up so often in my daily work that they almost become part of the background noise. A buyer asks about corrosion, another